perfWanIpv6

Value Type

IPv6

Default Value

This testvar’s default value is computed dynamically and may not always be the value below. Please see the testvar’s description for details.

3001::4

Description

This parameter specifies a free IPv6 address used for WAN-side performance tests. This IP will be the performance server’s IPv6 address. This IP address must be on the same network as the DUT’s WAN interface and next-hop gateway.

If not defined, the value of this testvar depends on the type of WAN connectivity, i.e. if the DUT is directly connected, or if there is a routed WAN setup.

In the typical case where CDRouter’s WAN interface is on the same network as the DUT’s WAN interface, this testvar defaults to the next address after ipv6WanIspNextIp. For example, if ipv6WanIspNextIp is 3001::3 then perfWanIpv6 would default to 3001::4. If ipv6WanIspNextIp is also not defined, check its description to determine its default value.

In the case of a routed WAN setup, where the DUT WAN interface and CDRouter WAN interface reside on different IPv6 links, this testvar is computed differently. Instead, this testvar defaults to the next address after ipv6WanIspGateway. For example, if ipv6WanIspGateway is 3001::2 then perfWanIp would default to 3001::3.

This testvar was added in CDRouter 9.3