uspProfilePath

Value Type

word

Default Value

This testvar must be explicitly defined in the configuration file

Description

This parameter specifies the full path of the user defined USP profile on the local system.

This testvar can also be set to “auto” which will cause CDRouter’s controller to perform a GetSupportedDM during start, the results will be used to construct a profile for testing based off the agent’s entire data model. When the “auto” mode is used the data model read from the agent will be written to the results directory in the BBF XML format. Note that the extracted data model is based on the parameters reported by the agent, if the information reported is incomplete the data model will be incomplete.

See the “USP Profile Testing” section of the CDRouter USP User Guide for more information.

This testvar was added in CDRouter 11.0