CDRouter Support


testvar version 13.3

Value Type


Minimum Value


Maximum Value


Default Value



The perfUploadBandwidth specifies the target upload bandwidth per stream, in Mbps, that CDRouter will attempt to transmit at during LAN-to-WAN performance tests.

The default value of 0 will result in CDRouter transmitting at the maximum bandwidth supported by the media type in use. For example, on a Fast Ethernet interface this will result in a transmit bandwidth of 100 Mbps.

If multiple streams are configured using the perfStream testvar, the transmit bandwidth per stream will be automatically calculated by diving the maximum supported bandwidth by the number of streams. For example, on a Fast Ethernet interface with the perfUploadBandwidth testvar set to 0, and the perfStreams testvar set to 10, the transmit bandwidth of each stream will be automatically set to 10 Mbps.

Specifying any other numerical value up to the maximum of 5000.00 will result in CDRouter attempting to transmit at the specified rate. If the testvar perfUploadBandwidth is set to a non-zero value and multiple streams are configured, the perfUploadBandwidth must be manually set to a value that is the aggregate target upload bandwidth divided by the number of streams. For example, if the target aggregate bandwidth is 500 Mbps with ten streams, the perfUploadBandwidth testvar should be set to a value of 50 Mbps. This will result in CDRouter transmitting at 50 Mbps on 10 streams for a total aggregate bandwidth of 500 Mbps.

For single client performance tests, maximum upload bandwidth is automatically capped at 2500 Mbps. For multi-client performance tests, the maximum aggregate upload bandwidth is automatically capped at 5000 Mbps.

Note that support for rates higher than 1000 Mbps requires an NTA1000v6 system equipped with 10 Gbps interfaces and a DUT with 2.5 / 5.0 / 10 Gbps interfaces.

This testvar was added in CDRouter 9.3



About CDRouter

QA Cafe CDRouter is a comprehensive and powerful test automation solution focused on feature, security, and performance testing for broadband and enterprise edge gateways, Wi-Fi and mesh systems, and other CPE.

Get in touch via our Contact page or by following us on your favorite service: