perfWanIp

Value Type

IPv4

Default Value

This testvar’s default value is computed dynamically and may not always be the value below. Please see the testvar’s description for details.

202.254.1.4

Description

This parameter specifies a free IP address used for WAN-side performance tests. This IP will be the performance server’s IPv4 address. This IP address must be on the same network as the DUT’s WAN interface and next-hop gateway.

If not defined, the value of this testvar depends on the type of WAN connectivity, i.e. if the DUT is directly connected, or if there is a routed WAN setup.

In the typical case where CDRouter’s WAN interface is on the same network as the DUT’s WAN interface, this testvar defaults to the next address after wanIspNextIp. For example, if wanIspNextIp is 202.254.1.3 then perfWanIp would default to 202.254.1.4. If wanIspNextIp is also not defined, check its description to determine its default value.

In the case of a routed WAN setup, where the DUT WAN interface and CDRouter WAN interface reside on different IP networks, this testvar is computed differently. Instead, this testvar defaults to the next address after wanIspGateway. For example, if wanIspGateway is 202.254.1.2 then perfWanIp would default to 202.254.1.3.

This testvar was added in CDRouter 9.3